Chrysler 1997 Stratus Convertible RHD Service Manual page 330

8K - 4 WINDSHIELD WIPERS AND WASHERS
DIAGNOSIS AND TESTING (Continued)
SHUTDOWN AUTOMATIC RADIATOR FAN HIGH RELAY (10) RELAY (12) SPEED
Fig. 4 Junction Block
Fig. 5 Power Distribution Center
(6) Using an ohmmeter, check from terminal 28 of
the HI-LO wiper relay to Pin A of the motor wire
connector for continuity. Check from terminal 11 of
the HI-LO wiper relay to Pin B of the motor wire
connector for continuity. If OK, go to Step 7. If not
repair as necessary.
(7) Using an ohmmeter, check for continuity
between the HI-LO wiper relay and the intermittent
wiper relay. Check from terminal 36 of the HI- LO
wiper relay to terminal 37 of the intermittent wiper
relay. If OK, check for faulty relays. If not repair as
NOT USED (8) TOR FAN RELAY (11) LOW SPEED RADIA- NOT USED (6) NOT USED (1) MOTOR STARTER ENGINE RELAY (9)
necessary.
TRANSMISSION CONTROL A/C INTERMITTENT HI/LO WIPER RELAY (4) FUEL PUMP RELAY (3) COMPRESSOR WIPER
CLUTCH RELAY (7) RELAY (5) RELAY (2)
(8) Disconnect the J3 14-way connector from the
BCM (Fig. 7).
(9) Using an ohmmeter, check for continuity from
terminal 7 of the J3 14-way connector to the terminal
15 of the intermittent wiper relay. If OK, go to Step
10. If not repair as necessary.
(10) Using a voltmeter, connect positive lead to ter-
minal 10 of the BCM J1 22-way connector and nega-
tive lead to ground (Fig. 8). Turn ignition switch to
the ON position. Slowly move the wiper switch from
OFF position through each position to HIGH.
mately 10 volts in the HIGH position, replace
BCM. If no voltage, go to Step 2.
from terminal 2 of wiper switch connector to termi-
nal 10 of the BCM J3 22-way connector. If no con-
tinuity, repair circuit. If OK, go to Step 11.
(11) Disconnect motor connector and replace fuse
15 from the Junction Block.
repair as necessary, refer to Group 8W, Wiring Dia-
grams.
Fig. 6 Motor Wire Connector
Fig. 7 Body Control Module 14-Way Connector
(a) If voltage increases from zero to approxi-
(b) Using an ohmmeter, check for continuity
(a) If fuse does not blow, go to Step 2.
(b) If fuse blows, wiper control circuit is at fault,
JX