Chrysler 1997 Stratus Convertible RHD Service Manual page 1013

CLUTCHES INPUT 3 DABS OF PETROLA- TUM RETAINER OVERDRIVE SHAFT ASSEM- FOR RETEN- TION BLY
JX
DISASSEMBLY AND ASSEMBLY (Continued)
DETERMINING No. 4 THRUST PLATE
THICKNESS—INPUT SHAFT END PLAY
To determine the proper thickness of the No. 4
thrust plate, select the thinnest No. 4 thrust plate.
Using petrolatum (Fig. 166) to hold thrust plate in
position, install input clutch assembly. Be sure the
input clutch assembly is completely seated (Fig. 167).
Fig. 166 Select Thinnest No. 4 Thrust Plate
CAUTION: If view through input speed sensor hole
Fig. 167 View Through Input Speed Sensor Hole
is not as shown above, the input clutches assembly
is not seated properly.
THINNEST #4 THRUST PLATE (SELECT) INPUT (TURBINE) SENSOR HOLE SPEED
OIL COOLER NIPPLES
OIL ASSEMBLY PUMP
INPUT SHAFT
USE 2 BOLTS TO
HOLD PUMP IN
PLACE
Fig. 168 Remove Oil Pump O-Ring
Remove the oil pump O-ring. You will be able to
install and remove the oil pump and gasket very eas-
ily to select the proper No. 4 thrust plate.
CAUTION: Be sure to reinstall O-ring on oil pump
after selecting the proper No. 4 thrust plate.
Fig. 169 Measure Input Shaft End Play
NOTE: Input shaft end play must be .005 to .025
inch.
For example, if end play reading is .055 inch, select
No. 4 Thrust Plate which is .071 to .074 thick. This
should provide an input shaft end play reading of
yes
O-RING
TRANSAXLE 21 - 45
USE A SMALL BOLT DIAL INDICATOR