Chrysler 1997 Stratus Convertible RHD Service Manual page 1031

JX
ADJUSTMENTS (Continued)
(c) Remove the existing shim from under the
cup.
(d) Measure the existing shim.
NOTE: If the turning torque was too high when
measured, install a .05 mm (.002 inch) thinner shim.
If the turning torque is was too low, install a .05 mm
(.002 inch) thicker shim. Repeat until 5 to 18 inch-
pounds turning torque is obtained.
Oil Baffle is not required when making shim
selection.
(e) Install the proper shim under the bearing
cup. Make sure the oil baffle is installed properly
in the bearing retainer, below the bearing shim
and cup.
(f) Install the differential bearing retainer using
Tool 5052 and C-4171. Seal the retainer to the
housing with MOPAR
torque bolts to 28 N·m (250 in. lbs.).
(7) Using Tool L-4436A and an inch-pound torque
wrench, recheck the turning torque of the differen-
tial. The turning torque should be between 5
and 18 inch-pounds.
Adhesive Sealant and
DIFFERENTIAL BEARING SHIM CHART
HIM
MM
.980
1.02
1.06
1.10
1.14
1.18
1.22
1.26
1.30
1.34
1.38
1.42
1.46
1.50
1.54
1.58
1.62
1.66
1.70
2.02
2.06
TRANSAXLE 21 - 63
THICKNESS
INCH
0.0386
0.0402
0.0418
0.0434
0.0449
0.0465
0.0481
0.0497
0.0512
0.0528
0.0544
0.0560
0.0575
0.0591
0.0607
0.0623
0.0638
0.0654
0.0670
0.0796
0.0812