JX
DESCRIPTION AND OPERATION
TRAVELER
Battery voltage for the traveler is supplied from
two (2) sources. One is the M1 circuit. This is the
Ignition-Off Draw (IOD) circuit and is protected by a
10 amp fuse located in the junction block. This cir-
cuit is HOT at all times.
Circuit A21 also supplies battery voltage to the
traveler when the ignition switch is in the START/
RUN position.
8W - 46 TRAVELER
8W-46 TRAVELER
Ground for the traveler is supplied on circuit Z1.
To allow the traveler to send and receive informa-
tion it is interfaced with the CCD Bus. Circuit D1 is
used for CCD (+), and circuit D2 is used for CCD (-).
Illumination lamps internal to the traveler are con-
trolled by circuit E2. This circuit is an output form
the Body Control Module (BCM).
Circuit C4 supplies a blower motor ON/OFF sense
to the traveler.
8W - 46 - 3