Chrysler 1997 Stratus Convertible RHD Service Manual page 952

ENGINE FRONT TRANSAXLE CROSSMEMBER FRONT CROSSMEMBER SUPPORT REAR BRACKET SUSPENSION MOUNTING BRACKET MOUNTING ATTACHING BOLTS BRACKET SUPPORT BOLT
19 - 38 STEERING
REMOVAL AND INSTALLATION (Continued)
Fig. 15 Rear Support Bracket Attachment To
Crossmember
Fig. 16 Engine Support Bracket To Transaxle
Bracket Bolt
Fig. 17 Crossmember To Body Attaching Bolts
BOLT CROSSMEMBER STABILIZER BAR LOWER CONTROL ARM STABILIZER BAR FRONT SUSPENSION MOUNTING BOLT CROSS- CROSSMEMBER MEMBER STEERING REAR GEAR POWER PRESSURE HOSE POWER STEERING GEAR STEERING
(20) Remove power steering fluid, pressure and
return hoses from the power steering gear assembly
(Fig. 18).
Fig. 18 Power Steering Pressure And Return Hose
(21) Remove wiring harness connector, (Fig. 18)
from the power steering fluid pressure switch.
(22) Remove the 2 bolts, at the isolators (Fig. 19)
and (Fig. 20) attaching the steering gear assembly to
front suspension crossmember. Then remove the 2
bolts attaching the steering gear saddle bracket (Fig.
21) to the front suspension crossmember. Remove the
steering gear assembly from the front suspension
crossmember.
Fig. 19 Steering Gear Rear Mounting Isolator Bolt
(23) Transfer required parts from removed steering
gear assembly to the replacement steering gear, if a
new steering gear is being installed.
INSTALL
(1) Install steering gear assembly on front suspen-
sion crossmember. Install the 2 long steering gear
assembly to front crossmember mounting bolts (Fig.
REAR MOUNTING BOLT FRONT CROSSMEMBER SUSPENSION POWER STEERING RETURN
At Steering Gear
STEERINGGEAR HOSE
JX