Chrysler 1997 Stratus Convertible RHD Service Manual page 283

END COVER KNEE BOLSTER
JX
REMOVAL AND INSTALLATION (Continued)
(1) Remove instrument cluster hood, refer to Clus-
ter Hood Removal and Installation procedures.
(2) Remove the four cluster attaching screws (Fig.
11).
(3) Remove instrument cluster and disconnect wire
connectors from instrument panel by pulling cluster
rearward.
INSTALLATION
For installation, reverse the above procedures.
INSTRUMENT PANEL
WARNING: DISCONNECT AND ISOLATE THE BAT-
TERY NEGATIVE (GROUND)
BEGINNING ANY AIRBAG SYSTEM COMPONENT
REMOVAL OR INSTALLATION PROCEDURE. THIS
WILL DISABLE THE AIRBAG SYSTEM.
SPEAKERS INSTRUMENT CLUSTER HVAC
CABLE BEFORE
Fig. 15 Instrument Panel Breakdown
INSTRUMENT PANEL AND SYSTEMS
FAILURE TO DISCONNECT BATTERY COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
ALLOW SYSTEM CAPACITOR TO DISCHARGE
FOR 2 MINUTES BEFORE REMOVING ANY AIRBAG
COMPONENTS.
REMOVAL
When removing a passenger airbag module refer to
Group 8M, Restraint Systems for Passenger Air Bag
Module Removal.
(1) Disconnect and isolate the battery negative
remote cable.
(2) Open both vehicle front doors. Remove left end
cover by pulling outboard. Remove right end cover by
pulling rearward (Fig. 15).
GLOVE BOX LOCK TOP COVER CENTER BEZEL CUBBYBIN SCREW CYLINDER PASSENGER BAG MODULE END COVER INSTRUMENT CLUS- AIR- RADIO TER HOOD
8E - 9