Svc Configuration; Setting The Svc Protocol; Specifying A Dlci Range For Svcs - HP auroraTempo User Manual

aurora Tempo - User Guide
Use Delete Bit
• Highlight Use delete Bit and press the RIGHT arrow
key to toggle between a tick ( ) or a cross ( ). When
a tick is displayed a delete bit is included to indicate
that the PVC has been deleted. This option is only
available if the asynchronous PVC STATUS request is
enabled (see above).

SVC Configuration

If you have set the Circuit type to either SVC or SVC & PVC,
you can set up parameters for switched virtual circuits
(SVCs) from the Link Configuration menu.

Setting the SVC Protocol

• Choose SVC Protocol to display a protocols sub-menu.
Choose from FRF4, X36, Q933A and Q933B.
2
Note
If you select Q933B the Circuit type defaults to SVC
only.

Specifying a DLCI Range for SVCs

You can define a range of DLCI values with upper and lower
limits for SVCs. This range is used when you automatically
add an SVC using the Next DLCI option (see Manipulating
PVCs & SVCs in Section 2 for further information).
Setting the minimum SVC DLCI
You can set the minimum DLCI value for an SVC from
the Link Configuration menu.
• Choose SVC Lower dlci to display a sub-menu.
• Enter a value in the given range - if the value is
outside this range *CHECK RANGE* is displayed.
5-8 423972