Interface Specifications - HP auroraTempo User Manual

aurora Tempo - User Guide

Interface Specifications

T1 Interface module
Conforms to ANSI T1.403 and has a bit rate of
1.544 Mbits/s
For Bantam connectors, it may be necessary to change
connectors when changing between simulate (DTE or DCE)
and Monitor modes (DTE or DCE).
Connectors
• 2 Bantam connectors for the receive ports
• 1 Bantam connector for the transmit port
• 1 RJ48C
DDS Interface module
Connectors
• 1 RJ48C connector (internally configured for
simulation or dual monitoring)
V-series Interface module
Connectors
• 37 way D type connector with 'personality' cables.
E1 Interface module
For the RJ48C connector, switching between DTE, DCE
and Monitor modes is performed automatically when the
Emulation setting on the Setup Config menu is changed.
For the BNC connectors it may be necessary to change
connectors when changing between simulate (DTE or DCE)
and Monitor modes (DTE or DCE).
Connectors
• 2 BNC connectors for the receive ports
• 1 BNC connector for the transmit port
• 1 RJ48C
A1 - 4
(V.35, RS-232, RS-449, EIA-530,X.21)
423972