Changing The Decode Mode; Applying Filters - HP auroraTempo User Manual

aurora Tempo - User Guide
Pausing data capture
• Press F2 Pause to pause the display of data to the
screen or its capture to the serial port or file. The active
screen freezes. This key has a toggle action and
Resume is displayed.
Resuming data capture
• If you have previously paused data capture, press F2
Resume to continue displaying data or capturing to
the serial port or file.
Pausing the display
• Press F3 Halt Screen to stop updating the screen
but to continue saving to file, if specified. This key
has a toggle action and Start Screen is displayed.
Resuming the display
• If you have previously paused the display, press F3
Start Screen to continue updating the screen.
Caution
Do not power-off aurora
file may be lost.

Changing the Decode Mode

You can display Frame Relay traffic in either full or
summarized decode format. Summary decode is the
default. To change the decode :
• Press F4 Decode Options and select Decode Mode
from the menu. The decode options are fully
described in Displaying Full or Summary Decode
Data in Section 4.

Applying Filters

You can apply existing filters to the display and capture of
data or you can create and apply new filters.
• Press F5 Logger Options to display the Logging
Options menu. Select the Log Filter option. This
lets you apply new and existing filters to the data. See
Using Filters in Section 4 for further information.
5-36
while recording data or the
Tempo
423972