HP auroraTempo User Manual page 157

Specifying the destination IP address
The destination address should be that of an active piece of
equipment on a valid DLCI. To specify the IP address of the
destination in dotted decimal format you input each
individual part of the decimal. The following diagram
shows how each part of the decimal is made up :
dest.aaa dest.bbb
• Highlight dest aaa and press the RIGHT arrow key to
display the dest aaa. sub-menu.
• Enter the first part of the decimal value. This must be
within the given range or *CHECK RANGE* is
displayed.
• Press ENTER to save and exit the sub-menu. The
Setup Test Config window displays the first part of
the destination IP address.
• Now repeat the above steps for dest .bbb, dest .ccc
and dest .ddd to input the rest of the destination
IP address.
Starting the test
• Choose Start Test from the PING Test Config menu.
The test begins and the test results are displayed in the Test
Results/Status window. This display is as follows :
Tx Ping
Issue 1a - 10/99
Frame Relay Testing - Section 3
dest.ccc
123 . 123 . 123 . 123
This is the number of IP frames
transmitted during the test
containing the Ping command,
and the type of ping frame
(Other, RFC1490 or Auto
Detect).
dest.ddd
5-77