HP auroraTempo User Manual page 147

• Use the RIGHT and LEFT arrow keys to move
between the other fields.
• Use the 0 and 1 keys or the UP and DOWN arrow keys
to switch the bits on or off.
• Press ENTER to exit the User Defined Header
window.
The user-defined header settings are only saved if
you perform a test using this header. When you
switch off aurora
settings are lost.
To exit the sub-menu without saving the settings,
press ESC.
Setting the Proportion of User-defined headers
If you have chosen to use a user-defined header, you can then
choose the proportion of frames used in the frame load test
that use the user-defined header. You can also choose how
the frames are distributed in the frame load.
To set the proportion of user-defined headers included:
• Highlight % of UDH and press the RIGHT arrow key
to display the % of UDH sub-menu.
• Enter the proportion of frames in the load using the
user-defined header. This must be between 0 and
100.
• Press ENTER to save and exit the % of UDH sub-
menu. The proportion of user-defined headers
entered is now displayed in the Setup Test Config
window.
Setting the Distribution of User-defined headers
You can set up the way the frames with user-defined headers
are distributed in the frame load. You can send the frames in
a burst or evenly spread through the frame load. The
remainder of the frames sent have default headers.
Issue 1a - 10/99
Frame Relay Testing - Section 3
Tempo the user-defined header
5-67