Performing A Receive Throughput Test - HP auroraTempo User Manual

Performing a Receive Throughput Test

This lets you test the CIR values at the receive side of the
interface.
2
Note
In order for aurora
know the Time Interval, the Committed Burst Size, the
Excess Burst Size and the Committed Information Rate.
To setup the Receive Throughput test:
• Choose Receive Throughput Test from the Setup Test
Config menu. The Receive Throughput Test Config
menu is displayed.
2
Note
The parameters you have to set up are similar to those for the
Variable Load Test - please refer to this test for further
information.
Starting the test
• Choose Start Test from the Receive Throughput
Config menu.
Issue 1a - 10/99
Frame Relay Testing - Section 3
Tempo to carry out this test, you have to
5-87