Applying A Configuration File - HP auroraTempo User Manual

aurora Tempo - User Guide
Entering a configuration file name
• Position the flashing cursor in the configuration file
name display area - press F1 to move the cursor to
the left, press F6 to move the cursor to the right.
• Use the UP, DOWN, LEFT and RIGHT arrow keys
on the cursor pad to navigate through the character
set. The currently selected character is highlighted in
a box.
• Press ENTER to choose the currently highlighted
character. The character appears in the
configuration file name display area. You can also
enter digits directly using the keypad.
• Repeat the above process until you have defined the
configuration file name.
Tips
• To delete a character, position the flashing cursor
over the character you want to delete (using F1 and
F6) and press F4 Delete.
Exiting from the configuration name window
• To exit and save your changes, press F2 Save & Exit.
The configuration file is saved in aurora
If the file name already exists, the maximum number of
files have been allocated, or insufficient file space
remains, a warning box is displayed. Press F1 or F6 to
close this box.
• To exit without making changes, press F3 Exit.

Applying a Configuration File

You can apply a previously defined Interface or System
Configuration file held in aurora
• Choose the Load Config function key. A list of user
defined configuration files is displayed.
• Choose the appropriate configuration file - the new
settings are applied and displayed.
6-16
's memory.
Tempo
's memory.
Tempo
423972