HP auroraTempo User Manual page 161

To set up the Variable Load test:
• Choose Variable Load Test from the Setup Test
Config menu. The Variable Load Test Config menu is
displayed.
Specifying the Transmit CIR
To specify the value of the transmit Committed Information
Rate (CIR) :
• Highlight Tx CIR in the Variable Load Test Config
menu and press the RIGHT arrow key to display
the Tx CIR sub-menu.
• Enter the transmit CIR value - this value must be
within the given range or *CHECK RANGE* is
displayed.
• Press ENTER to save and exit the sub-menu. The
Setup Test Config window displays the Transmit CIR
value.
Specifying the Transmit Bc
To specify the transmit Committed Burst Size (Bc):
• Highlight Tx Bc in the Variable Load Test Config
menu and press the RIGHT arrow key to display
the Tx Bc sub-menu.
• Enter the transmit Bc value - this value must be
within the given range or *CHECK RANGE* is
displayed.
• Press ENTER to save and exit the sub-menu. The
Setup Test Config window displays the Transmit Bc
value.
Issue 1a - 10/99
Frame Relay Testing - Section 3
5-81