Stopping A Test - HP auroraTempo User Manual

Rx:
Bits
Bc Bits
Be Bits
Discard
Rate (bps)

Stopping a Test

When a test is in progress you can stop it at any time. To
do this :
• Press the F1 Stop Test function key to stop the test.
The Test field in the DLCI Management window
displays No Test Active against the DLCI.
Issue 1a - 10/99
Frame Relay Testing - Section 3
This is the total number of bits
received.
This is the number of bits received
above the Committed Burst Size.
This is the number of bits received
above the Excess Burst Size.
When the number of frames being
transmitted or received is higher
than the figures you specified for
the Be and Bc when you set up
the test, these fields show the
number of additional frames.
These fields indicate the current
transmit/receive bit rates for
traffic on the DLCI.
5-89