HP auroraTempo User Manual page 162

aurora Tempo - User Guide
Specifying the Transmit Be
To specify the value of the transmit Excess Burst Size (Be):
• Highlight Tx Be in the Variable Load Test Config
menu and press the RIGHT arrow key to display
the Tx Be sub-menu.
• Enter the transmit Be value - this value must be
within the given range or *CHECK RANGE* is
displayed.
• Press ENTER to save and exit the sub-menu. The
Setup Test Config window displays the Transmit
Be value.
Specifying the Transmit Tc
To specify the value of the transmit Time Interval (Tc):
• Highlight Tx Tc in the Variable Load Test Config
menu and press the RIGHT arrow key to display
the Tx Tc sub-menu.
• Enter the transmit Tc value - this value must be
within the given range or *CHECK RANGE* is
displayed.
• Press ENTER to save and exit the sub-menu. The
Setup Test Config window displays the Transmit
Tc value.
Specifying the Receive CIR
To specify the value of the receive Committed Information
Rate (CIR) :
• Highlight Rx CIR in the Variable Load Test Config
menu and press the RIGHT arrow key to display
the Rx CIR sub-menu.
• Enter the receive CIR value - this value must be within
the given range or *CHECK RANGE* is displayed.
• Press ENTER to save and exit the sub-menu. The
Setup Test Config window displays the Receive CIR
value.
5-82 423972