Configuring an Interface
•
Press the Config Physical function key.
2
Note
If both interfaces are already assigned Config not
possible. Interfaces already assigned is displayed.
Press F1 or F6 to close the warning box.
•
Choose the interface you wish to configure - either
Interface A or Interface B. The following interface
configuration menu is displayed :
Choosing the Emulation Type
You can set up aurora
equipment on a Frame Relay network.
•
Choose Emulation to display a sub-menu of
emulation types - these are as follows :
DTE
DDS
DDS
DCE
DDS
DDS
Issue 1a - 10/99
Configuring aurora
to emulate different types of
Tempo
Data Terminal Equipment
Data Communications Equipment
Tempo
6-3