HP auroraTempo User Manual page 165

• Enter the transmit interval - this value must be within
the given range or *CHECK RANGE* is displayed.
• Press ENTER to save and exit the sub-menu.
Specifying the Transmit Interval Time
Use this option to specify the length of time you want to test
for at each interval between the start and end transmit rates.
• Highlight Tx Int Time in the Variable Load Test
Config menu and press the RIGHT arrow key to
display the Tx Int Time sub-menu.
• Enter the transmit interval time - this value must be
within the given range or *CHECK RANGE* is
displayed.
• Press ENTER to save and exit the sub-menu.
Starting the test
• Choose Start Test from the Variable Load Test Config
menu.
The test begins and the test results are displayed in the Test
Results/Status window. This display is as follows :
Issue 1a - 10/99
Frame Relay Testing - Section 3
5-85