Connecting & Disconnecting Svcs - HP auroraTempo User Manual

aurora Tempo - User Guide
• Choose the Deactivate PVC option. The DLCI is
deactivated and the status shows Inactive on the
DLCI Management window.
Connecting & Disconnecting SVCs
The following menu options are only available if the Circuit
Type is set to SVC or both - refer to Choosing the Circuit
Type in Section 1 of this chapter for further information.
Connecting an SVC
You can set up and connect a Switched Virtual Circuit (SVC)
from the DLCI Management window.
2
Note
• If the SVC protocol is not active you cannot connect or
disconnect an SVC. If you choose Next DLCI or Enter
DLCI an error message is displayed.
• Press the MENU key to display the DLCI Management
menu.
• Choose SVC Connect to display the SVC DLCI sub-
menu.
This sub-menu has the following options :
Next DLCI
Enter DLCI
5-44
Choose this option to add the next
DLCI in the range. The DLCI
Management window displays
statistics for the new DLCI.
Choose this option to enter a new DLCI
value - a sub-menu is displayed. Enter a
valid DLCI value. Press ENTER to save
and exit. This number must be within
the given range or *CHECK RANGE* is
displayed. The DLCI Management
window displays statistics for the new
DLCI.
423972