Connecting for a point-to-point configuration
The point-to-point connection is technically a LAN connection, with only two
nodes.
•
•
•
Figure 3
Point-to-point Connection
Use the supplied 10Base-T cable (HP part number 5061-7342) to connect
the Pentium probe directly to the prototype analyzer (see figure 3).
The configuration switches must be set for a LAN configuration. Switch 1
must be set to OPEN, indicating that a LAN connection is being made.
Since this is a 10BASE-T connection, switch 5 must also be set to OPEN
(see figure 5).
Use the procedure in "Setting Up LAN Communication" to set the Ethernet
address, IP address, and gateway address.
Connecting the Probe to the Prototype Analyzer
Connecting for a point-to-point configuration
9