HP auroraTempo User Manual page 163

Specifying the Receive Bc
To specify the value of the receive Committed Burst Size
(Bc):
• Highlight Rx Bc in the Variable Load Test Config
menu and press the RIGHT arrow key to display
the Rx Bc sub-menu.
• Enter the receive Bc value - this value must be
within the given range or *CHECK RANGE* is
displayed.
• Press ENTER to save and exit the sub-menu. The
Setup Test Config window displays the Receive Bc
value.
Specifying the Receive Be
To specify the value of the receive Excess Burst Size (Be):
• Highlight Rx Be in the Variable Load Test Config
menu and press the RIGHT arrow key to display the
Rx Be sub-menu.
• Enter the receive Be value - this value must be within
the given range or *CHECK RANGE* is displayed.
• Press ENTER to save and exit the sub-menu. The
Setup Test Config window displays the Receive Be
value.
Specifying the Receive Tc
To specify the value of the receive Committed Rate Interval
(Tc):
• Highlight Rx Tc in the Variable Load Test Config
menu and press the RIGHT arrow key to display the
Rx Tc sub-menu.
• Enter the receive Tc value - this value must be within
the given range or *CHECK RANGE* is displayed.
• Press ENTER to save and exit the sub-menu. The
Setup Test Config window displays the Receive Tc
value.
Issue 1a - 10/99
Frame Relay Testing - Section 3
5-83