Performing A Variable Load Test - HP auroraTempo User Manual

aurora Tempo - User Guide
Starting the test
• Choose Start Test from the PING Receive Test Config
menu.
The test begins and the test results are displayed in the Test
Results/Status window. This display is as follows :
Rx Ping
Tx Ping Reply
Unknown Frms

Performing a Variable Load Test

This test allows you to apply an increasing load to a line. You
can specify the starting load, the maximum load, the size of
the steps used, and the rate that the load is increased at. You
can set up the test to load the line so that it exceeds, equals
or falls below the CIR settings.
2
Note
In order for aurora
know the Committed Time Interval, the Committed Burst
Size, the Excess Burst Size and the Committed
Information Rate.
5-80
This is the number of IP frames
received during the test
containing the Ping command, and
the type of ping frame (RFC1490
or Other).
This is the number of IP Ping
Reply frames transmitted during
the test.
This is the number of non-ping
frames received during the test.
to carry out this test, you have to
Tempo
423972