Installing An Fpc In An M40E Router; Figure 104: Removing An Fpc From An M40E Router - Juniper M40E Hardware Manual

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
CAUTION: After removing an FPC from the chassis, wait at least 30
seconds before reinserting it, removing an FPC from a different slot, or
inserting an FPC into a different slot.

Figure 104: Removing an FPC from an M40e Router

Installing an FPC in an M40e Router

To install an FPC (see Figure 105 on page 195 and Figure 106 on page 196):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see "Preventing Electrostatic Discharge Damage to an M Series, MX Series, or T Series
Router" on page 232.
Verify that the ends of the ejector levers, which are located at each end of the FPC,
2.
are pushed outward, nearly perpendicular to the face of the FPC.
Grasp the front of the FPC with one hand and place the other hand under the FPC to
3.
support it.
CAUTION: When the FPC is out of the chassis, do not hold it by the ejector
levers, bus bars, or edge connectors. They cannot support its weight.
Chapter 16: Replacing M40e Hardware Components
193