Installing A T640 Fpc; Figure 164: Removing A T640 Fpc - Juniper T640 Hardware Manual

T640 Core Router Hardware Guide

Installing a T640 FPC

336

Figure 164: Removing a T640 FPC

To install an FPC (see Figure 166 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place the FPC on an antistatic mat.
2.
Take each PIC to be installed in the replacement FPC out of its electrostatic bag, and
3.
identify the slot on the FPC where it will be connected.
Verify that each fiber-optic PIC has a rubber safety cap covering the PIC transceiver.
4.
If it does not, cover the transceiver with a safety cap.
340):
Copyright © 2017, Juniper Networks, Inc.