Related
Documentation
Replacing an MX104 Management Ethernet Cable
Related
Documentation
Replacing an MX104 Fiber-Optic Cable
Copyright © 2014, Juniper Networks, Inc.
Connect one end of the replacement cable into the
2.
Plug the other end of the cable into the device's serial port.
3.
MX104 Routing Engine Auxiliary and Console Ports Specifications on page 179
Removing an MX104 Management Ethernet Cable on page 87
1.
Installing an MX104 Management Ethernet Cable on page 87
2.
Removing an MX104 Management Ethernet Cable
To remove a serial cable connected to a management device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Press the tab on the connector, and pull the connector straight out of the
2.
port.
Figure 25 on page 87
Disconnect the cable from the network device.
3.
Figure 25: Ethernet Cable Connectors
Installing an MX104 Management Ethernet Cable
To install a serial cable connected to a management device:
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Plug one end of the replacement cable into the appropriate
2.
Plug the other end of the cable into the network device.
3.
MX104 Routing Engine Ethernet Port Specifications on page 177
Disconnecting an MX104 Fiber-Optic Cable on page 87
1.
2.
Connecting an MX104 Fiber-Optic Cable on page 88
Disconnecting an MX104 Fiber-Optic Cable
The MX104 router has field-replaceable unit (FRU) optical transceivers to which you can
connect fiber-optic cables.
Chapter 13: Replacing MX104 Hardware Components
CONSOLE/AUX
shows the connector.
port.
ETHERNET
port.
ETHERNET
87