Version
9.11(0.0)
9.10(0.0)
9.9(0.0)
Related Commands
•
•
•
enable
Enable a specific SupportAssist activity.
Syntax
enable
To disable a particular SupportAssist activity, use the no enable command.
Defaults
Enabled
Command Modes
SUPPORTASSIST ACTIVITY FULL-TRANSFER
SUPPORTASSIST ACTIVITY CORE-TRANSFER
SUPPORTASSIST ACTIVITY EVENT-TRANSFER
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.11(0.0)
9.10(0.0)
9.9(0.0)
Usage Information
Enter the specific SupportAssist activity mode and then enable it.
Related Commands
•
SupportAssist Company Commands
Dell Networking OS supports the following SupportAssist Company mode commands.
1588
SupportAssist
Description
Introduced on the M I/O Aggregator and FN IOM.
Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON,
Z9500, MXL.
action-manifest get
— copy an action-manifest file for an activity to the system.
action-manifest install
— configure the action-manifest to use for a specific activity.
action-manifest remove
— remove the action-manifest file for an activity.
Description
Introduced on the M I/O Aggregator and FN IOM.
Introduced on the C9010, Z9100–ON, S6100–ON, and S3100 series.
Introduced on the S4810, S4820T, S3048–ON, S4048–ON, S5000, S6000, S6000–ON,
Z9500, MXL.
NOTE:
By default, the full transfer includes the core files. When you disable the core transfer activity,
the full transfer excludes the core files.
activity
— move user to the SupportAssist Activity mode for that activity.