Show Vlt Inconsistency - Dell S6100 Configuration Manual

Example
Dell# Dell(conf-if-vl-100)#show vlt detail
Local LAG Id Peer LAG Id Local Status Peer Status Active VLANs
------------ ----------- ------------ ----------- -------------
10

show vlt inconsistency

Display run-time inconsistencies in the incoming interface (IIF) for spanned multicast routes (mroutes).
Syntax show vlt inconsistency ip mroute
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.2(0.2)
9.2(0.0)
9.0.2.0
Example
Dell#show vlt inconsistency ip mroute
Spanned Multicast Routing IIF Inconsistency
Multicast Route
---------------
(22.22.22.200, 225.1.1.2) VLAN 5
(*, 225.1.1.2)
Dell#
show vlt mismatch
Display mismatches in VLT parameters.
Syntax show vlt mismatch
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
1682 Virtual Link Trunking (VLT)
10 UP
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S6000.
LocalIIF
----------
VLAN 15
Description
Introduced on the S6100–ON.
UP 100, 200, 300, 400,
PeerIIF
---------
VLAN 6
te 1/1/1/1