Storm-Control Multicast (Configuration) - Dell S6100 Configuration Manual

Parameters
packets_per_secon
d in
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
7.4.1.0
6.5.1.0

storm-control multicast (Configuration)

Configure the packets per second (pps) of multicast traffic allowed into the C-Series and S-Series networks only.
Syntax storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_secon
d in
Defaults none
Command Modes CONFIGURATION (conf)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Enter the packets per second of broadcast traffic allowed into the network. The range is
from 0 to 33554368.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
E-Series Only: Added the percentage decimal value option.
Introduced on the E-Series.
Enter the packets per second of multicast traffic allowed into the network. The range is
from 0 to 33554368.
Storm Control 1559