Polling-Interval - Dell S6100 Configuration Manual

• show storm-control multicast
• show storm-control unknown-unicast
• storm-control broadcast (Configuration)
• storm-control broadcast (Interface)
• storm-control multicast (Configuration)
• storm-control multicast (Interface)
• storm-control unknown-unicast (Configuration)
• storm-control unknown-unicast (Interface)

polling-interval

You can set the time interval to poll the queue depth and egress counters.
Syntax polling—interval {interval in milli-seconds}
Parameters
interval in milli-
seconds
Defaults 100 milli-seconds
Command Modes CONFIGURATION (conf-storm-control-pfc)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
Usage Information The polling—interval command is used to set the interval in milliseconds to poll the queue traffic and egress
counters. You can use the polling results to detect the inconsistencies in the PAUSE frames received .
Example Use the storm-control pfc command in the configuration mode to enter the 'storm-control-pfc'
configuration mode. The commands provisioned in this mode are applicable for all the interfaces that have PFC
storm enabled.
Dell(conf)#storm-control pfc
Dell(conf-storm-control-pfc)#polling-interval 200
xoff-state threshold polling-count
When a lossless queue in an interface is not able to forward traffic for a particular duration of time, it is detected as PFC storm. You can set
the duration by providing the number of polling intervals. If a port/priority remains in xoff state for the specified duration, then it is detected
as PFC storm condition.
Syntax xoff-state threshold polling-count {number of polling-interval}
Parameters
number of polling
interval
Defaults 2
Command Modes CONFIGURATION (conf-storm-control-pfc)
1548 Storm Control
Enter the polling interval in milliseconds. The range is 200 to 1000. The interval should be
entered in multiples of 100. The default interval value is 100 milliseconds.
Description
Introduced on the S6000, S6000–ON, S61000–ON, Z9100–ON.
Enter the number of polling intervals. The range is from 2 to 10.