Show Vlt Brief - Dell S6100 Configuration Manual

Version
9.0.2.0
8.3.19.0
8.3.8.0
Usage Information After you configure a VLT domain on each peer switch and connect (cable) the two VLT peers on each side of the
VLT interconnect, the system elects a primary and secondary VLT peer device. To configure the primary and
secondary roles before the election process, use the primary-priority command. Enter a lower value on the
primary peer and a higher value on the secondary peer.
If the primary peer fails, the secondary peer (with the higher priority) takes the primary role. If the primary peer
(with the lower priority) later comes back online, it is assigned the secondary role (there is no preemption).

show vlt brief

Displays summarized status information about VLT domains configured on the switch.
Syntax show vlt brief
Default Not configured.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.8.0
Usage Information The version shown in the show vlt brief output command displays the VLT version number which is different
from the Dell Networking OS version number. VLT version numbers begin with odd numbers.
Example (Brief)
Dell#show vlt brief
VLT Domain Brief
------------------
Domain ID
Role
Role Priority
ICL Link Status
HeartBeat Status
VLT Peer Status
1678 Virtual Link Trunking (VLT)
Description
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
: 1
: Secondary
: 32768
: Up
: Up
: Up