Snmp-Server Engineid - Dell S6100 Configuration Manual

Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.8(0.0)
9.7(0.0)
9.2(1.0)
9.2(0.0)
9.0.2.0
9.1(0.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.4.1.0
7.6.1.0
7.5.1.0
E-Series legacy
command
Usage Information
Dell Networking OS supports up to 16 SNMP trap receivers.
If you do not configure this command, traps that controlled by this command are not sent. If you do not specify a
notification-type and notification-option, all traps are enabled.
Related Commands
•

snmp-server engineID

Configure the name for both the local and remote SNMP engines on the router.
Syntax snmp-server engineID [local engineID] [remote ip-address vrf vrf-name udp-port
port-number engineID]
To return to the default, use the no snmp-server engineID [local engineID] [remote ip-
address vrf vrf-name udp-port port-number engineID] command.
Parameters
local engineID
1502 Simple Network Management Protocol (SNMP) and Syslog
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added the following two SNMP notification options: syslog-reachable and
syslog-unreachable.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S6000.
Added support for copy-config and ECMP traps.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for VRRP traps.
Added support for STP and xSTP traps. Introduced on the S-Series.
Introduced on the C-Series.
snmp-server community — enables SNMP and sets the community string.
Enter the keyword local followed by the engine ID number that identifies the copy of
the SNMP on the local device.