Sflow Polling-Interval (Interface) - Dell S6100 Configuration Manual

Defaults 20 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
8.1.1.0
7.7.1.0
7.6.1.0
7.4.1.0
Usage Information The polling interval for an interface is the maximum number of seconds between successive samples of counters
sent to the collector. This command changes the global default counter polling (20 seconds) interval. You can
configure an interface to use a different polling interval.
Related Commands
•

sflow polling-interval (Interface)

Set the sFlow polling interval at an interface (overrides the global-level setting.)
Syntax sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
interval value
Defaults The same value as the current global default counter polling interval.
Command Modes INTERFACE
1488 sFlow
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
sflow polling-interval (Interface)
Enter the interval value in seconds. The range is from 15 to 86400 seconds. The default is
the global counter polling interval.
— sets the polling interval for an interface.