Vrrp Delay Minimum - Dell S6100 Configuration Manual

To delete one or more virtual IP addresses, use the no virtual-address ip-address1 [... ip-
address12] command.
Parameters
ip-address1
... ip-address12
Defaults Not configured.
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
7.4.1.0
6.2.1.1
Usage Information
The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address. When you
delete the virtual address, the VRRP group stops sending VRRP packets.
A system message appears after you enter or delete the virtual-address command.
To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual IP address with the same
address as the interface's primary IP address and change the priority of the VRRP group to 255.
You can ping the virtual IP addresses configured in all VRRP groups.

vrrp delay minimum

Set the delay time for VRRP initialization after an interface comes up.
Syntax vrrp delay minimum seconds
Enter an IP address of the virtual router in dotted decimal format. The IP address must be
on the same subnet as the interface's primary IP address.
(OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted decimal
format. Separate the IP addresses with a space. The IP addresses must be on the same
subnet as the interface's primary IP address.
Description
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced support for telnetting to the VRRP group IP address assigned using this
command.
Introduced on the E-Series.
Virtual Router Redundancy Protocol (VRRP) 1721