Logging Version - Dell S6100 Configuration Manual

Version
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command
Usage Information To block a type of message parameter, set the logging trap level to a lower number. For example, to block severity
messages at level 6, set the level to 5.
Related Commands
•
•

logging version

Displays syslog messages in a RFC 3164 or RFC 5424 format.
Syntax logging version {0|1}
Defaults 0
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.5(0.0)
Usage Information
To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version command in configuration
mode. By default, the system log version is set to 0.
The following describes the two supported log messages formats:
•
•
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series, S55.
Introduced on the C-Series.
logging — enables the logging to another device.
logging on — enables logging.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
0 – Displays syslog messages format as described in RFC 3164, The BSD syslog Protocol
1 – Displays SYSLOG message format as described in RFC 5424, The Syslog Protocol
Simple Network Management Protocol (SNMP) and Syslog 1535