Dell S6100 Configuration Manual page 1717

ipv6
vrf vrf-name
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.4.(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage Information The following describes the show vrrp brief command.
Item
Interface
Grp
Pri
Pre
State
• For a VLAN interface, enter the keyword vlan, and then the VLAN ID. The VLAN ID
range is from 1 to 4094.
(OPTIONAL) Enter the keyword ipv6 to view only VRRP IPv6 groups.
(OPTIONAL) Enter the keyword vrf and then the name of the VRF to view active VRRP
groups corresponding to that VRF.
EXEC
EXEC Privilege
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Added support for VRF.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Lists the interface type, slot, and port of the configured VRRP group.
Displays the VRRP group ID.
Displays the priority value assigned to the interface. If you configured the track
command to track that interface and you disable the interface, the cost is subtracted
from the priority value assigned to the interface.
States whether preempt is enabled on the interface:
• Y = Preempt is enabled.
• N = Preempt is not enabled.
Displays the operational state of the interface using one of the following:
Virtual Router Redundancy Protocol (VRRP) 1717