Show Protocol-Tunnel - Dell S6100 Configuration Manual

Version
8.3.11.1
8.3.7.0
8.2.1.0
7.4.1.0
Example
Dell(conf-if-vl-2)# vlan-stack compatible
Dell(conf-if-vl-2-stack)#protocol-tunnle rate-limit 100 <<<<<<<< VLAN stack
mode
Dell(conf-if-vl-2-stack)#show config
!
interface Vlan 2
no ip address
mtu 1000
vlan-stack compatible
protocol-tunnel rate-limit 100
shutdown
Related Commands
•
•

show protocol-tunnel

Display protocol tunnel information for all or a specified VLAN-Stack VLAN.
Syntax show protocol-tunnel [vlan vlan-id]
Parameters
vlan vlan-id
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
1480 Service Provider Bridging
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and E-Series. Maximum rate limit on E-Series reduced from
4000 to 3000.
Introduced
show protocol-tunnel — displays tunneling information for all VLANs.
show running-config — displays the current configuration.
(OPTIONAL) Enter the keyword vlan then the VLAN ID to display information for the
one VLAN. The range is from 1 to 4094.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.