Dell S6100 Configuration Manual page 1512

Parameters
name
group_name
remote ip-address
vrf vrf-name
udp-port port-
number
1 | 2c | 3
encrypted
auth
md5 | sha
auth-password
priv
des56 | aes128
priv password
access access-list-
name
1512 Simple Network Management Protocol (SNMP) and Syslog
Enter the name of the user (not to exceed 20 characters), on the host that connects to
the agent.
Enter a text string (up to 20 characters long) as the name of the group. The following
groups are created for mapping to read/write community/security-names (defaults):
• v1v2creadu — maps to a community with ro permissions.
• 1v2cwriteu — maps to a community rw permissions.
Enter the keywords udp-port then the user datagram protocol (UDP) port number on
the remote device. The range is from 0 to 65535. The default is 162.
Enter the keywords vrf and then the name of the VRF this is used to connect to the
SNMP server.
NOTE: Use this attribute to specify a VRF name that is used to connect to the
remote host. If no VRF is specified, then the default VRF is used.
Enter the keywords udp-port then the UDP (User Datagram Protocol) port number on
the remote device. The range is from 0 to 65535. The default is 162.
(OPTIONAL) Enter the security model version number (1, 2c, or 3):
• 1 is the least secure version.
• 3 is the most secure of the security modes.
• 2c allows transmission of informs and counter 64, which allows for integers twice the
width of what is normally allowed.
The default is 1.
(OPTIONAL) Enter the keyword encrypted to specify the password appear in
encrypted format (a series of digits, masking the true characters of the string).
(OPTIONAL) Enter the keyword auth to specify authentication of a packet without
encryption.
(OPTIONAL) Enter the keyword md5 or sha to designate the authentication level.
• md5 — Message Digest Algorithm
• sha — Secure Hash Algorithm
(OPTIONAL) Enter a text string (up to 20 characters long) password that enables the
agent to receive packets from the host. Minimum: eight characters long.
(OPTIONAL) Enter the keywords priv to initiate a privacy authentication level setting.
(OPTIONAL) Enter the keyword des56 or aes128 to specify the encryption mode.
• aes128 — Use 128 bit AES algorithm in CFB mode for encryption.
• des56 — Use 56 bit DES algorithm in CBC mode for encryption.
(OPTIONAL) Enter a text string (up to 20 characters long) password that enables the
host to encrypt the contents of the message it sends to the agent. Minimum: eight
characters long.
(Optional) Enter the standard IPv4 access list name (a string up to 16 characters long).