Usage Information
When you enable debug spanning-tree bpdu for multiple interfaces, the software only sends information on
BPDUs for the last interface specified.
Related Commands
•
description
Enter a description of the spanning tree.
Syntax
description {description}
To remove the description from the spanning tree, use the no description {description} command.
Parameters
description
Defaults
none
Command Modes
SPANNING TREE (The prompt is "config-stp".)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
Related Commands
•
disable
Disable the spanning tree protocol globally on the switch.
Syntax
disable
To enable Spanning Tree Protocol, use the no disable command.
protocol spanning-tree
— enters SPANNING TREE mode on the switch.
Enter a description to identify the spanning tree (80 characters maximum).
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
protocol spanning-tree
— enter SPANNING TREE mode on the switch.
Spanning Tree Protocol (STP)
1567