Version
6.2.1.1
Related Commands
•
•
protocol spanning-tree
To enable and configure the spanning tree group, enter SPANNING TREE mode.
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree stp-id command.
Parameters
stp-id
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.5.1.0
6.2.1.1
Usage Information
STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the switch, use the no
disable command from SPANNING TREE mode.
Example
Dell(conf)# protocol spanning-tree 0
Dell(config-stp)#
Description
Introduced on the E-Series.
forward-delay
— changes the wait time before STP transitions to the Forwarding state.
hello-time
— changes the time interval between BPDUs.
Enter zero (0). Dell Networking OS supports one spanning tree group, group 0.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Spanning Tree Protocol (STP)
1571