Dell S6100 Configuration Manual page 1644

Defaults Not configured.
Command Modes CONF-IF-VLAN
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.6.1.0
E-Series original
Command
Usage Information
Prior to disabling the stackable VLAN feature, remove the members.
To view the stackable VLANs, use the show vlan command in EXEC Privilege mode. Stackable VLANs contain
members, designated by the M in the Q column of the command output.
If you enabled VRF, you cannot enable the stacked VLAN feature using this command.
If you enabled IGMP snooping, you cannot enable the stacked VLAN feature using this command.
Example
Dell# show vlan
Codes: * - Default VLAN, G - GVRP VLANs
*
Dell#
1644 VLAN Stacking
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
NUM Status Q Ports
1 Inactive
2 Active M Te 1/1/1/1
M Te 1/1/1/1-1/1/1/3
3 Active M Po1(Te 1/1/4/1-1/1/4/2)
M Te 1/1/8/1
M Te 1/1/4/3
4 Active M Po1(Te 1/1/4/1-1/1/4/2)
M Te 1/1/8/1
M Te 1/1/5/1
5 Active M Po1(Te 1/1/4/1-1/1/4/2)
M Te 1/1/8/1
M Te 1/1/6/1