Vxlan-Instance Static - Dell S6100 Configuration Manual

Version
9.8(1.0)
9.8(0.0)
9.4(0.0)
Usage Information You must disable vxlan-instance before unconfiguring VAP.
Related Commands feature vxlan

vxlan-instance static

Enable VXLAN instance configuration to be static on the platform.
Syntax vxlan-instance instance ID [static]
To delete VXLAN instance from the system, use no vxlan-instance instance ID command.
Parameters
instance ID
static
Defaults Controller mode.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Version
9.11(0.0)
Usage Information
By default, VXLAN instance is created in controller mode. You need a controller to configure VTEP. When you
create VXLAN instance in static mode, you can configure VTEP through CLIs.
Use the no shutdown command to enable the VXLAN instance.
Only one VXLAN instance can exist in a system.
You cannot modify a VXLAN instance mode. If you need to change the mode, you can delete the existing VXLAN
instance and create a new instance with the required mode.
Example
Enable VXLAN instance:
Dell(conf)#feature vxlan
Dell(conf)#vxlan-instance 1 static
Dell(conf-vxlan-inst-1)#no shutdown
Disable VXLAN instance:
Dell(conf)#no vxlan-instance 1 static
1698 Virtual Extensible LAN (VXLAN)
Description
Introduced on the Z9100–ON.
Introduced on the S4048–ON.
Introduced on the S6000.
— Enable VXLAN configuration globally on the platform.
Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the initial
release.
Enter the keyword static to set the VXLAN instance in static mode.
Description
Introduced on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON, and
Z9100–ON.