Role - Dell S6100 Configuration Manual

inherit existing-role-
name
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.0)
Usage Information
By default, access to commands are determined by the user's role (if defined) or by the user's privilege level. If the
aaa authorization role-only command is enabled, then only the user's role is used.
Before you enable role-based only AAA authorization:
1
2
3
4
5
Related Commands login authentication, password, radius-server host, tacacs-server host

role

Changes command permissions for roles.
Syntax role mode { { { addrole | deleterole } role-name } | reset } command
To delete access to a command, use the no role mode role-name
Parameters
mode
1468 Security
Enter the inherit keyword then specify the system defined role to inherit permissions
from (sysadmin, secadmin, netadmin, netoperator).
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Locally define a system administrator user role.This will give you access to login with full permissions even if
network connectivity to remote authentication servers is not available.
Configure login authentication on the console. This ensures that all users are properly identified through
authentication no matter the access point
Specify an authentication method (RADIUS, TACACS+, or Local).
Specify authorization method (RADIUS, TACACS+ or Local).
Verify the configuration has been applied to the console or VTY line.
Enter one of the following keywords as the mode for which you are controlling access:
configure for CONFIGURATION mode
exec for EXEC mode
interface for INTERFACE modes