Storm-Control Broadcast (Interface) - Dell S6100 Configuration Manual

Parameters
percentagedecimal
_value in | out
wred-profile name
packets_per_secon
d in
Defaults none
Command Modes CONFIGURATION (conf)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.2(0.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
7.4.1.0
6.5.1.0
Usage Information Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast traffic is treated as
unknown-unicast traffic.

storm-control broadcast (Interface)

Configure the percentage of broadcast traffic allowed on an interface (ingress only).
Syntax storm-control broadcast [packets_per_second in]
To disable broadcast storm control on the interface, use the no storm-control broadcast
[packets_per_second in] command.
1558 Storm Control
Enter the percentage of broadcast traffic allowed in or out of the network. Optionally, you
can designate a decimal value percentage, for example, 55.5%. The decimal range is
from .1 to .9.
Enter the keyword wred-profile followed by the profile name to designate a wred-profile.
Enter the packets per second of broadcast traffic allowed into the network. The range is
from 0 to 33554368.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-MUX
(PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
E-Series Only: Added the percentage decimal value option.
Introduced on the E-Series.