Maximum Dynamic-Routes - Dell S6100 Configuration Manual

Version
9.4.(0.0)
Usage Information
When you use this command, the management ports corresponding to both the active unit and the standby unit
are associated with the management VRF.

maximum dynamic-routes

Specify the maximum number of dynamic (protocol) routes a VRF can have.
Syntax maximum dynamic-routes limit {warn-threshold threshold-value | warning-only}
To remove the limit on the maximum number of routes used, use the no maximum dynamic-routes
command.
Parameters
limit
warning-threshold
warning-only
Defaults No limit is set on the maximum number of dynamic routes for a VRF.
Command Modes
CONFIGURATION-VRF
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.4(0.0)
Usage Information
If you do not specify the maximum route limit for a VRF, the VRF has unlimited space that extends to the maximum
number of entries allowed for the system.
Description
Introduced on the S-Series and Z9000.
Maximum number of routes allowed in a VRF. The valid range is from 1 to 320,000 (or
maximum allowable for that platform if a smaller value).
The warning threshold value is a percentage of the limit value. When the number of
routes reaches the specified percentage of the limit, a warning message appears. The
valid range is from 1 to 100.
After the limit is reached, additional dynamic routes are not allowed.
When you use the warning-only option, when the maximum number of dynamic
routes reaches the limit, a warning message appears.
After the limit is reached, additional dynamic routes are still allowed.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON and Z9500.
Introduced on the S–Series.
Virtual Routing and Forwarding (VRF) 1659