Snmp-Server Contact - Dell S6100 Configuration Manual

Dell(conf)# snmp-server community guest ro snmp-ro-acl
Dell(conf)#
Related Commands
•
•
•

snmp-server contact

Configure contact information for troubleshooting this SNMP node.
Syntax snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server contact command.
Parameters
text
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command
1500 Simple Network Management Protocol (SNMP) and Syslog
ip access-list standard — names (or selects) a standard access list to filter based on IP address.
ipv6 access-list — configures an access list based on IPv6 addresses or protocols.
show running-config — displays the current SNMP configuration and defaults.
Enter an alphanumeric text string, up to 55 characters long.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.