Debug Vrrp - Dell S6100 Configuration Manual

Version
6.2.1.1
Usage Information

debug vrrp

Enable VRRP debugging.
Syntax debug vrrp [vrrp-id] {all | bfd | database | interface | ipv6 | packets | state
| timer}
To disable debugging, use the no debug vrrp [vrrp-id] {all | bfd | database | interface
| ipv6 | packets | state | timer} command.
Parameters
vrrp-id
all
bfd
database
interface
interface
ipv6
packets
1710 Virtual Router Redundancy Protocol (VRRP)
Description
Introduced on the E-Series.
NOTE: This command also enables you to clear the port configurations corresponding to a range of
ports. However, for Open Networking (ON) platforms the notation for specifying port range in the
command is different from how you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if you want
to clear the port configurations corresponding to all ports between 1 and 4, specify the port range as
clear counters interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] - slot/port/
[subport]. For example, if you want to clear the port configurations corresponding to all ports
between 1 and 4, specify the port range as clear counters interfaces interface-type
1/1/1 - 1/1/4.
(OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
Enter the keyword all to enable debugging of all VRRP groups.
Enter the keyword bfd to enable debugging of VRRP BFD interactions.
Enter the keyword database to enable debugging of configuration changes.
Enter the following keywords and the interface information:
• For Port Channel interface types, enter the keywords port-channel then the
number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID range
is from 1 to 4094.
Enter the keyword interface to enable debugging of interface state changes.
Enter the keyword ipv6 to enable debugging for IPv6.
Enter the keyword packets to enable debugging of VRRP control packets.