Version
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
8.1.1.0
7.7.1.0
7.6.1.0
6.2.1.1
Usage Information
This command changes the sampling rate for an interface. By default, the sampling rate of an interface is set to the
same value as the current global default sampling rate. If the value entered is not a correct power of 2, the
command generates an error message with the previous and next power-of-2 value. Select one of these two
number and re-enter the command.
Related Commands
•
show sflow
Display the current sFlow configuration.
Syntax
show sflow [interface]
Parameters
interface
Description
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
sflow sample-rate (Global)
(OPTIONAL) Enter the following keywords and slot/port or number information:
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
•
For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
•
For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
•
For the Management interface on the, enter the keyword ManagementEthernet
then the slot/port information.
— changes the sampling rate globally.
sFlow
1491