Router-Id - Dell S6100 Configuration Manual

router-id

Designate a fixed router ID.
Syntax router-id ip-address
To return to the previous router ID, use the no router-id ip-address command.
Parameters
ip-address
Defaults The router ID is selected automatically from the set of IPv4 addresses configured on a router.
Command Modes
ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
9.1.(0.0)
8.3.19.0
7.8.1.0
7.4.1.0
Usage Information
You can configure an arbitrary value in the IP address for each router. However, each router ID must be unique.
If this command is used on an OSPFv3 process that is already active (has neighbors), all the neighbor adjacencies
are brought down immediately and new sessions are initiated with the new router ID.
Related Commands
•
Enter the router ID in the dotted decimal format.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced support for OSPFv3 on the S4810 and Z9000.
Introduced on the S4820T.
Added support for the C-Series.
Introduced on the E-Series.
clear ipv6 ospf process – reset an OSPFv3 router process.
Open Shortest Path First (OSPFv2 and OSPFv3) 1175