Version - Dell S6100 Configuration Manual

Version

8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage Information
The VRRP group only becomes active and sends VRRP packets when you configure a virtual IP address. When you
delete the virtual IP address, the VRRP group stops sending VRRP packets.
Related Command
•
version
Set the VRRP protocol version for the IPv4 group.
Syntax version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2
3
both
Defaults 2
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.5(0.0)
1724 Virtual Router Redundancy Protocol (VRRP)
Description
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
virtual-address — assigns up to 12 virtual IP addresses per VRRP group.
Enter the keyword 2 to specify VRRP version 2 as defined by RFC 3768, Virtual Router
Redundancy Protocol.
Enter the keyword 3 to specify VRRP version 3 as defined by RFC 5798, Virtual Router
Redundancy Protocol.
Enter the keyword both for in-service migration from VRRP version 2 to VRRP version 3.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the Z9000, S6000, S4820T, S4810, and MXL.