Ssh And Scp Commands - Dell S6100 Configuration Manual

Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts:
Mac-Auth-Bypass:
Mac-Auth-Bypass Only:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Host Mode:
Auth PAE State:
Backend State:
Dell#

SSH and SCP Commands

Dell Networking OS supports secure shell (SSH) protocol versions 1.5 and 2.0. SSH is a protocol for secure remote login over an insecure
network. SSH sessions are encrypted and use authentication.
crypto key generate
Generate keys for the SSH server.
Syntax
crypto key generate {rsa | rsa1}
Parameters
rsa
rsa1
Defaults Key size 1024; if you enable FIPS mode, the key size is 2048.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
1436 Security
NOTE: Some of the parameters in this command require licensing to access. For more information,
contact your Dell Networking representative.
Enter the keyword rsa then the key size to generate a SSHv2 RSA host keys. The range
is from 1024 to 2048 if you did not enable FIPS mode; if you enabled FIPS mode, you can
only generate a 2048-bit key. The default is 1024.
NOTE:
information, contact your Dell Networking representative.
Enter the keyword rsa1 then the key size to generate a SSHv1 RSA host keys. The
range is from 1024 to 2048. The default is 1024.
NOTE:
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Disable
NONE
NONE
Disable
Disable
30 seconds
60 seconds
2
30 seconds
30 seconds
3600 seconds
2
SINGLE_HOST
Initialize
Initialize
You must have a license to access the FIPS mode. For more
This option is not available in FIPS mode.